CDMA850 Mobile Phone  signal booster Coverage 150m2

 

Description 

There are millions of very small areas (10~150 square meters) where people work or live in and suffer from very poor or no mobile signals. People are seeking a cheap and immediate solution that would allow them have clear phone calls or higher speed broad band. However most of the current repeater solutions usually have larger coverage size, which is cost effective. HPC-C10 is specifically designed as a "CHEAP" solution to meet this request.

1. The consumer repeater is an ideal solution for providing a costeffective improvement in cellular in-building coverage of a home, office, restaurant or building, in the quickest time possible.

2. Manual gain control (MGC total 31dB range with all DIP switches for each link) available for both uplink and downlink to adjust the gain value for proper coverage during installation or maintenance.

3. To maintain safe and specific output signal levels and give alarms on self-oscillation, the repeater has built-in AGC and ALC circuits, which can automatically control the gain of the repeater depending upon the strength of input signals.

4. Auto shut off function available for both uplink and downlink to avoid deep self-oscilation from jamming the towers, saving your trouble from operators.

 

5. It supports two systems of CDMA 850mhz .

Electrical Specification				Uplink	Downlink
FreqencyRange	CDMA			824-869MHz	869-894MHz
Max Gain				≥63dB	≥68dB
Max Output power				≥10dB	≥14dB
Band Width		CDMA		25MHz
MGC(Step Attenuation				≥15dB/5dB step
Automatic Level Control				≥15dB auto shut off after 15dB
Gain Flatness		CDMA		≤8dB
Noise Figure				≤7dB
VSWR				≤2.5
Group Delay				≤1.5μs
Frequency stability				≤0.01ppm
Inter-modulation			9KHz~1GHz	≤-20dBm	≤-20dBm
			1GHz~12.75GHz	≤-20dBm	≤-20dBm
Spurious Emission			9KHz~1GHz	≤-36dBm	≤-36dBm
			1GHz~12.75GHz	≤-30dBm	≤-30dBm

 

 

LED Alarm	Standard
P : Power indicator	Be lighted when the adaptor work fine
UL: UL signal indicator	Be lighted when there is phone useing
DL: DL signal indicator (there are 3 DL LED )	1.Only the first DL be lighted means signal not good
	2.The first and second DL be lighted means signal is good
	3.All Three DL be lighted means signal up to the best state

 

Mechanical Specification	Standard
I /O Port	N-Female
Impedance	50 ohm
Operating Temperature	-25ºC~+55ºC
Environment Conditions	IP40
Dimensions	155*112*85mm
Color	silver
Weight	≤1.50Kg
Power Consumption	≤8W
Power Supply	Input AC90~264V,45~55Hz, Output DC5V/3A

No comment

Total 0 records, divided into1 pages. First Prev Next Last

Comment

Usename：	Anonymous user
E-mail：
Evaluation grade：
Content：
Verification code：

消费满49-98元 赠DIY心情预报草，绿意清心，夏日好心情！数量有限送完为止

消费满149元 赠喷水加湿手持便携小风扇,盛夏来临，保湿降温防暑一下搞定！